Categories

News

When The Sawdust Briquette Machine Needs Maintenance Work
Jul 02, 2018

After using a period, we should pay attention to the work situation of the biomass briquette making machine. If there is any problem as below, you should take maintenance work to your machine.

IMG_1226.jpg

  1. The working efficiency of the coal rod machine has dropped significantly;

  2. The defective rate of the coal bars increased significantly;

  3. The rods are made faster, but the structure is loose and the density is too low;

  4. The wear of the front end of the coal rod machine is greater than 4mm;

  5. The inner diameter of the prepared coal rod is less than 10 mm;

  6. Falling into hard materials such as stones and iron nails causes severe wear on the spiral part of the coal rod machine;

  7. The raw materials are normal, and the head of the coal rod machine often jams and cannot be produced normally;

  8. Although the coal rods can be formed, they cannot be joined together because they are detached from one section;

  9. An abnormal sound occurs in the speed reducer and the rotating part, which is required to be filled with lubricating oil;

  10. After the coal rod machine is used, it is necessary to clean the internal debris in the engine body so as to avoid blockage caused by excessive hardening;


  • QR CODE
  • facebook